Welcome to VapeOWave DIY Eliquid / Ejuice & Personal Vaporizer Mods Store based in Centurion, Boksburg, South Africa. You will find all mods, tanks, accessories and DIY EJuice needed to convert to E-Smoking / Vaping and premium E-Liquids on our website

10 Meter Cut-to-Length Pure Nickel Ni200 / Ni201 Coil Wire 24AWG (0.50mm) Zero Resistance heating wire - Rebuild RBA (0.04 - 0.1Ohm) Coils

Be the first to review this product

Availability: Out of stock

R65.00
    • Reward Points Purchasing this item you will earn 1 Point
    • Applies only to registered customers, may vary when logged in.

Quick Overview

Please note!! Ni200 / Ni201 wire is to be used by experienced vapers only. When using Ni200 / Ni201 wire for rebuilding coils you MUST have a temperature controlled Mod / Device such as the Evic VT which will control the wire temperatures to ensure you are not exposed to any danger.

If your Mod / Device is not temperature controlled please use Kanthal A1 28 AWG, Kanthal A1 26AWG, Kanthal A1 24AWG to rebuild your coil.

This pure Nickel wire is commonly used to rebuild the RBA Deck Coil supplied with Kanger Subtank Mini / Plus but can also be used for coil rebuild for Aspire / Atlantis and other RBA Decks with a temperature controlled mod used. To assist in rebuilding your coil use the RDA / RBA Deck Toolkit

Ni201 / Ni200 wire will allow you to reach subohm resistances of as low as 0.1 Ohm depending on number of winds of coil.

10 Meter Ni200 / Ni201 Coil Wire 24AWG (0.50mm) Zero Resistance heating wire - Rebuild RBA (0.1 - 0.3Ohm) Coils

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

  • 10 Meter Ni200 / Ni201 Coil Wire 24AWG (0.50mm) Zero Resistance heating wire - Rebuild RBA (0.1 - 0.3Ohm) Coils

Details

Please note!! Ni200 / Ni201 wire is to be used by experienced vapers only. When using Ni200 / Ni201 wire for rebuilding coils you MUST have a temperature controlled Mod / Device such as the Evic VT which will control the wire temperatures to ensure you are not exposed to any danger.

If your Mod / Device is not temperature controlled please use Kanthal A1 28 AWG, Kanthal A1 26AWG, Kanthal A1 24AWG to rebuild your coil.

This pure Nickel wire is commonly used to rebuild the RBA Deck Coil supplied with Kanger Subtank Mini / Plus but can also be used for coil rebuild for Aspire / Atlantis and other RBA Decks with a temperature controlled mod used. To assist in rebuilding your coil use the RDA / RBA Deck Toolkit

When rebuilding a coil the organic cotton on the RBA Deck will also needs to be replaced and sheets can be found here.

Ni201 / Ni200 wire will allow you to reach subohm resistances of as low as 0.06 Ohm depending on number of winds of coil.

 

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.